Cisco Network Assistant MAC auth issue

Unanswered Question
Mar 22nd, 2010
User Badges:

I have few Autonomous Access Points all managed by the Cisco Network Assistant. Users have access to wireless only based on MAC authentication.


Every once in a while the wireless access to the Access-Point fails and the following error is showed in the Cisco Network Assistant.


ERROR: The MAC address filter 700 used for association access was not created by the web interface and cannot be displayed.


also


WARNING: Filter 700 was configured on interface Dot11radio 0.170 using CLI. It must be cleared via CLI to ensure proper operation of the web interface.


The Network Admin does not use CLI but this problem keeps coming. To fix this problem I had cleared the access-list 700 via CLI and created a new access-list 700 via Cisco Network Assistant. Adding all the MAC's each time the network goes down is a cumbersome process. Is there a solution for this?


Thanks in advance


error snapshot attached.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content