03-24-2010 05:36 AM - edited 07-03-2021 06:39 PM
I have an access point that is stuck in my AP group. The AP group is the premade group called default group. I tried powering the AP down and clearing the config. This didn't work. The AP would never lose its name no matter how many times I cleared the config.
The AP is a 1131 and our controller is a 4404 with Software Version 6.0.188.0.
Any ideas on what I should do?
03-24-2010 08:08 PM
Did you assign the AP to another group and did you try to set the AP Group under the WLAN Advanced AP Group tab or the AP Advanced tab?
03-25-2010 10:33 AM
I tried putting the ap in the AP group using WLAN/advance/ap groups and wireless/ap name/advance. When I tried it using the second method it give me this error: http://img708.imageshack.us/i/errora.jpg/
03-25-2010 01:22 PM
Is it just one AP.... if so, maybe beteer just to tftp the rcv image again and start from scratch.... take you less than 5 minutes.
03-30-2010 07:10 AM
do you know of any documentation on how to do this?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: