Solved: How to show "ip local pool" information?

hplonline · ‎03-25-2010

I'm doing simulation in Packet Tracer 5.2. I need to setup ezvpn on router 2811.

There's a command configuring a local ip pool like this:

#ip local pool mypool 192.168.1.100 192.168.1.110

My question is how to check out what local pools are there and what ip is in each pool ?

Is there any command like "sh ip int br" other than "sh run"?

andrew.prince · ‎03-25-2010

The issue is with the simulator - it's got just enough functionality to perform basic tasks.

The command is available in full router IOS.

HTH>

andrew.prince · ‎03-25-2010

show ip local pool

HTH>

hplonline · ‎03-25-2010

Thanks. But the command is invalid in my simulator.

Is this the problem of Packet Tracer 5.2?

Or, is this command available on real 2811 router..?

Thanks, again.

andrew.prince · ‎03-25-2010

The issue is with the simulator - it's got just enough functionality to perform basic tasks.

The command is available in full router IOS.

HTH>

hplonline · ‎03-25-2010

Oh, I see. You're so quick. Thanks.

andrew.prince · ‎03-25-2010

my lunch time!

NP.