03-25-2010 08:35 AM - edited 03-06-2019 10:19 AM
Hi All,
Am trying to find a way,where only some members of the port-channel would be used until the load increase the active member capacity .If this is not possible,Also exploring a way to keep some member active and only other members become active when any or some of the active members link goes down .
Thanks for the help
Regards
Anantha Subramanian Natarajan
03-25-2010 10:31 AM
Hello Anantha,
you can have some hot standly links when using LACP
LACP allows to configure priority on a port basis
The device with the best system-id like an STP root bridge decides what links are active and what are placed in hot-standby state
see the section about hot standby links, they are used for redundancy only when one of the primary links fail (no load level trigger)
Hope to help
Giuseppe
03-25-2010 12:03 PM
Thank you Giuseppe
Regards
Anantha Subramanian Natarajan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: