cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
375
Views
0
Helpful
2
Replies

Always busy tone is coming with H.323 outbound calls

haseeb
Level 1
Level 1

Hello Experts,

With H.323/FXO only four specific IP Phones can make outside calls and when i try to call outside call from remaining IP Phones it gives busy tone. Please check the H.323 gateway configuration below and let me know what could be the possible issue:

sh run
Building configuration...


Current configuration : 3976 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname TS_VOIP_GATEWAY
!
boot-start-marker
boot-end-marker
!
! card type command needed for slot/vwic-slot 0/2
!
no aaa new-model
dot11 syslog
!
!
ip cef
!
!
no ip domain lookup
multilink bundle-name authenticated
!
trunk group  FXO1
!
!
trunk group  1
max-calls any 4
description trunk group for FXO Ports
hunt-scheme round-robin
!
voice-card 0
no dspfarm
!
voice class h323 1
h225 timeout tcp establish 3
!
archive
log config
  hidekeys
!
interface FastEthernet0/0
ip address 192.168.80.254 255.255.255.0
duplex auto
speed auto
!
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 192.168.80.200
!
ip http server
no ip http secure-server
!
control-plane
!
!
!
voice-port 0/0/0
supervisory disconnect dualtone mid-call
output attenuation -3
cptone KW
timeouts interdigit 2
timeouts call-disconnect 5
timeouts wait-release 5
connection plar 4001
caller-id enable
!
voice-port 0/0/1
compand-type a-law
cptone KW
timeouts interdigit 2
connection plar opx 5555
caller-id enable
!
voice-port 0/0/2
compand-type a-law
cptone KW
timeouts interdigit 2
connection plar opx 7397
description *Operator no*
caller-id enable
!
voice-port 0/0/3
compand-type a-law
cptone KW
timeouts interdigit 2
connection plar opx 7858
caller-id enable
!
!
!
!
!
dial-peer voice 7337 voip
destination-pattern 4001
voice-class h323 1
session target ipv4:192.168.80.10
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 5555 voip
destination-pattern 5555
voice-class h323 1
session target ipv4:192.168.80.10
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 7858 voip
destination-pattern 7858
voice-class h323 1
session target ipv4:192.168.80.10
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 7397 voip
destination-pattern 7397
voice-class h323 1
session target ipv4:192.168.80.10
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 1 pots
destination-pattern [2-9].......
port 0/0/0
!
dial-peer voice 2 pots
destination-pattern [2-9].......
port 0/0/1
!
dial-peer voice 3 pots
destination-pattern [2-9].......
port 0/0/2
!
dial-peer voice 4 pots
destination-pattern [2-9].......
port 0/0/3

2 Replies 2

William Bell
VIP Alumni
VIP Alumni

You only have four POTS lines/ports in your configuration.  So, if there are 4 IP phones using 4 ports there is no more pie left for the other phones.  Which is why they are getting a busy tone most likely.   Unless there are some other ports/variables I am missing.

Oh, BTW the trunk group configuration you have in the config is not engaged until you actually assign ports to it (using the trunk-group <....> command under the voice-port) and configure dial-peers to use it (using trunkgroup under dial-peer).  Just an FYI.

HTH.

Regards,
Bill

Please remember to rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

Thank you for your response. I am only able to call outside from the numbers mentioned in PLAR under voice port i.e. 4001 , 5555 , 7858 etc. If i will call from other extensions then it will give busy tone.

It's not necessary that only these numbers should make outside calls. I want all the IP Phones to use these four lines based on their availability.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: