I recently installed LMS 3.2 (and the latest updates for CM, RME and HUM) and am experiencing some really strange behaviour in Campus Manager.
After running a data acquisition job, the campus manager portal lists 41 devices (as expected), and I see a number of Best Practice Deviations, etc.
When I click on the Best Practice Deviations, it generates the details in the report as expected, however, when I click on the number of devices (the hyperlink in the main CM portal page) I get the message below:
No devices managed in Campus Manager. Run Data Collection and launch again.
I imported the list of devices from our ACS database into DCR successfully and verified all the connectivity through RME (I'm getting good config backups so I know the DCR objects and credentials are correct), and the deviations and discrepancies reports work properly, however, I'm a little confused as to what I missed in terms of telling CM WHICH devices to manage?
In the device selection, I have it set to Auto Mode, and have selected "All Devices".
However when I go to the "Include Devices" section, all of the groups are empty. Even if I click on "All Devices" the number of selected devices shown is always zero. (ie: it's like CM doesn't see ANY devices in the DCR)
But really strange is when I go to the "Excluded Devices" and click on "All Devices", it shows the 41 devices in the selected list??
I thought I'd pose the question here before getting TAC involved, thanks in advance for any insight you can provide!
This is what I thought. I would not have moved from Windows 2008 64-bit, especially to Windows 2003. The direction is Windows 2008, and 64-bit will have a longer life than 32.
Your problem is a known bug, CSCtd49439. A patch is available from TAC to fix this.