Configuring EtherChannel Using NME-16ESW

Unanswered Question
Mar 27th, 2010
User Badges:

Hi Folks,

While configuring L3 EtherChannel on NME 16ESW module I am not able to get "Channel-Group 1 mode on" command.

I am easily able to make L2 EtherChannel.  I am using 12.4 (12) IOS. Kindly have a look at the below configurations:

R0(config)#int port-channel 1

R0(config-if)#no switchport

R0(config-if)#ip address

R0(config)#interface range fastEthernet 1/14 - 15

R0(config-if-range)#no switchport


% Unrecognized command

R0#sh ver

Cisco IOS Software, 3600 Software (C3640-JK9O3S-M), Version 12.4(12), RELEASE SOFTWARE (fc1)

Kindly advice as to what could be the possible error.

Let me know if I need to provide any other information.



m. +91-9902017491

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
glen.grant Sat, 03/27/2010 - 13:39
User Badges:
  • Purple, 4500 points or more

  Looks ok ,I would try and put it on the individual ports instead of using the interface range command and see what happens , could be a bug .

Edison Ortiz Sat, 03/27/2010 - 17:02
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

Layer 3 EC is not supported under NM-16ESW



Each time you rate a CSC   discussion we'll donate $1 to the American Red Cross Haiti fund up to a   maximum donation of $10,000 USD.


This Discussion