Trunking from 881W to WLAN Service Module

Unanswered Question
Mar 29th, 2010

Should I be able to trunk multiple VLANs between an 881w and its installed wlan-ap service module?

I can route between the 2 as long as I set up a subnet on vlan1, but I cannot get anything going if I create VLAN100 on the router and the service module and put the IP address on the service module.

I've created int g0.100 and given that encapsulation dot1q 100, I set bridge-group 100

on BVI100 I've set the IP 172.29.6.1/24

on the router I've set interface Wlan-GigabitEthernet0 to switchport mode trunk

I've created vlan100 and set an IP (for testing) of 172.29.6.2/24

I cannot ping between the two.

any suggestions?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

Related Content