Alcatel 4400 - Cisco H323 VG

Unanswered Question
Mar 30th, 2010

Hi,

We need to integrate an Alcatel 4400 PBX with our Cisco CallManager 6.1 using a Cisco 2811 H323 VG.

We will use an Alcatel PRA-2 card on the Alcatel PBX and an E1 card on Cisco VG.

The link will use QSIG.

1- What kind of cable should we use? (straight, crossed, 1-2-4-5...)

2- Is there any updated doc detailing the Cisco and Alcatel configuration?

3- Is there any special requirements for this integration, any recommendations...?

Thanks for your help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
aketata@3s.com.tn Wed, 12/15/2010 - 08:33

Hi,

Yes we did it.

First, one of Alcatel guys must do Alcatel config for you.

Second, we put a Cisco VG and connected the Alcatel PBX via an E1 (1/2/4/5 connection).

Please find the configuration of the controller :

interface Serial0/0/1:15
   no ip address
   encapsulation hdlc
   isdn switch-type primary-qsig
   isdn overlap-receiving
   isdn incoming-voice voice
   isdn negotiate-bchan
   isdn sending-complete
   no cdp enable

Attached a Cisco doc describing the Alcatel configuration steps.

Good Luck !

Actions

This Discussion

Related Content