cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1363
Views
0
Helpful
4
Replies

Dynagen on real Network

I have a problem with a dynamips/dynagen  topology. 

I have build a real network based on 28xx Router. To complete the  plateform I have to connect a 7200 Cisco Router (using emulation because  I don't have materiel). 

With different method I tried to connect them like that : 

Quote:
# Simple lab test 7200 PE

[localhost]

[[7200]]
# image = \Program  Files\Dynamips\images\c7200-jk9o3s-mz.124-7a.image
# On Linux / Unix use forward slashes:
image = /opt/dynamips/images/c7200-adventerprisek9-mz.124-24.T2.bin
npe = npe-400
ram = 256


[[ROUTER R1]]
slot1 = PA-FE-TX
f0/0 = NIO_gen_eth:eth1



The aim is to 7200 interface fa 0/0 and interface to a real Router 28xx  are on the same subnet and dialog without errors. 
It not works !! Have you any Idea ?? 

Using FEDORA

4 Replies 4

Ganesh Hariharan
VIP Alumni
VIP Alumni

I have a problem with a dynamips/dynagen  topology. 

I have build a real network based on 28xx Router. To complete the plateform I have to connect a 7200 Cisco Router (using emulation because  I don't have materiel). 

With different method I tried to connect them like that : 

Quote:
# Simple lab test 7200 PE

[localhost]

[[7200]]
# image = \Program  Files\Dynamips\images\c7200-jk9o3s-mz.124-7a.image
# On Linux / Unix use forward slashes:
image = /opt/dynamips/images/c7200-adventerprisek9-mz.124-24.T2.bin
npe = npe-400
ram = 256


[[ROUTER R1]]
slot1 = PA-FE-TX
f0/0 = NIO_gen_eth:eth1



The aim is to 7200 interface fa 0/0 and interface to a real Router 28xx  are on the same subnet and dialog without errors. 
It not works !! Have you any Idea ?? 

Using FEDORA

Hi,

Check out the below link for dynagen to connect with real network.

http://netguide.sakura.ne.jp/dynamips/english/real-network.html

Hope to Help !!

Remember to rate the helpful post

Ganesh.H

Cisco will donate $1 to  the Red Cross Haiti fund for every rated post!
https://supportforums.cisco.com/docs/DOC-8727

ok I understand but I use FEDORA so Linux System. It not the same thing about the descriptor !!

Moreover, He doesn't explain his ip configuration !! do you think he put a static IP address ??

Problem solve :

the config in the .net is not with ''gen'' but ''linux''.

So it is like that :

f0/0 = NIO_linux_eth:eth1

Thanks

Problem solve :

the config  in the .net is not with ''gen'' but ''linux''.

So it is like that :

f0/0 =  NIO_linux_eth:eth1

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco