03-30-2010 02:55 PM - edited 03-15-2019 10:02 PM
When configuring a device on a CCM 7.x and VG224, do you have telnet to to the VG as you wold in a VG248 or it it all done through the admin portion of the CCM via Device > Gateway?
I have built a user and when plugged in, their is dial tone, but noting happens when dialing from that port.
Am I missing something?
03-30-2010 03:02 PM
Hi
Yes, it's an IOS gateway.
You configure it like you would an ISR - go in and do the SCCP or MGCP config from the box in conjunction with the CCM side stuff.
Regards
Aaron
Please rate helpful posts...
03-30-2010 03:32 PM
The devise is already setup, it is adding users/ports that is the issue.
03-30-2010 03:53 PM
If you're doing SCCP (keyword in IOS is "stcapp"), you configure the stations as SCCP devices similar to phones.
If you're doing MGCP on the gateway, you configure the ports within the gateway configuration page on a port-by-port basis.
Hailey
Please rate helpful posts!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: