03-31-2010 12:23 AM - edited 03-04-2019 07:58 AM
Dear All,
I having problem to configure E1 card (VWIC2-1 MFT E1 ) to get aggregate Bandwidth.can anybody tell that how to configure 3 E1 card in a router to get 6 Mbps bandwidth as one E1 support 2 Mbps bandwidth.Please need you assistance on this issue.I am not able to finish the project with this configuration.
I am keenly waiting for your valuable help.
Thanks and regards..
Erfan
03-31-2010 12:48 AM
Hi Erfan
You have an option of creating a MLPPP bundle on the router and you can use 3E1 for that
thxz...
Manish
03-31-2010 12:55 AM
Hi Manish,
Thanks for your prompt support.Can you tell me any documents for this configuration.
I am keenly waiting for your reply.
Thanks and regards...
Erfan
03-31-2010 01:10 AM
03-31-2010 06:50 AM
This is a simple config. Just remove all layer 3 config from the serial interfaces and do this
interface multilink 1
ip address 192.168.1.1 255.255.255.0
encap ppp
ppp mul
ppp mul group 1
!
int serial 1/0:0
encap ppp
ppp mul
ppp mul group 1
!
int serial 1/1:0
encap ppp
ppp mul
ppp mul group 1
!
int serial 2/0:0
encap ppp
ppp mul
ppp mul group 1
Configure all the serial interfaces identically and have the Layer 3 config on the multilink interface. Do the same on the other end.
03-31-2010 11:53 PM
Hi Ronit,
Thanks for your reply and help.I will configure accordingly.I will let you know if i face any problem.
Thanks and regards...
Erfan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: