I have a question about adding two new members in a existing Stack of Catalysts 3750E.
As I read in the Cisco document (http://www.cisco.com/en/US/customer/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml#tshoot) that the Stack fully connected must be half connected in order to add the new members. My question is if at that point: when i disconnect one Stackwise cable from my fully connected Stack, is there any disruption of traffic forwarding in the Stack?
Thanks in advance, Juan Enrique
I see - then no, there should be no outage as long as all the ports are properly connected except the one you are removing...
Do a 'show switch stack-ports' on the CLI to verify it's all UP/OK, and check that they are physically well-seated and screwed in firmly.
As with any maintenance, do this at a quiet time/evening just in case you have an unexpected problem.