ā03-31-2010 06:40 AM - edited ā03-17-2019 09:58 PM
Hi All,
I have a problem on FXO card. And I think that it is problem of configuration
I call numbers of line connected in FXO card, and I take down the call before the IP Phone answers me, the IP Phone continues sounded without stop, (approximately 120s)
Here configuration of chart FXO:
voice-port 0/1/1
no battery-reversal
output attenuation -6
cptone FR
timeouts interdigit 2
timeouts call-disconnect 0
timeouts wait-release 1
connection plar 130
impedance complex2
Thank you for your Help
ā03-31-2010 06:53 AM
Hi
Sounds like a Supervisory Disconnect problem - you may also find that if you hang up the outside line after you have called, it doesn't disconnect promptly either?
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
What country are you in?
Aaron
ā03-31-2010 08:22 AM
thank your for your answer
iam from morocco
ā03-31-2010 09:20 AM
Hi
OK, so I've not done this in your country...
Your best option is to go through some trial and error using some of the options in that document I posted. Apply one config, then shut/no shut the port and test it again.
Regards
Aaron
ā03-31-2010 11:58 AM
To begin with, use "connection plar opx".
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: