Probleme With FXO Card

oelmassaoudi · ‎03-31-2010

Hi All,

I have a problem on FXO card. And I think that it is problem of configuration

I call numbers of line connected in FXO card, and I take down the call before the IP Phone answers me, the IP Phone continues sounded without stop, (approximately 120s)

Here configuration of chart FXO:

voice-port 0/1/1

no battery-reversal

output attenuation -6

cptone FR

timeouts interdigit 2

timeouts call-disconnect 0

timeouts wait-release 1

connection plar 130

impedance complex2

Thank you for your Help

Aaron Harrison · ‎03-31-2010

Hi

Sounds like a Supervisory Disconnect problem - you may also find that if you hang up the outside line after you have called, it doesn't disconnect promptly either?

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml

What country are you in?

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

oelmassaoudi · ‎03-31-2010

thank your for your answer

iam from morocco

Aaron Harrison · ‎03-31-2010

Hi

OK, so I've not done this in your country...

Your best option is to go through some trial and error using some of the options in that document I posted. Apply one config, then shut/no shut the port and test it again.

Regards

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

paolo bevilacqua · ‎03-31-2010

To begin with, use "connection plar opx".