03-31-2010 10:45 AM - edited 03-06-2019 10:24 AM
Hi
I’m trying to get a WS-C3750-48TS-S (Version 12.2(35)SE5) to connect to two different core switches which run HSRP between them (4006, 4506)
Right now
interface GigabitEthernet1/0/1
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1-4,1005-4094
switchport mode trunk
on the WS-C3750-48TS-S is connected to the 4006 (Version NmpSW: 6.3(5)) on 4/3 (Module 4 is a WS-X4306-GB). This is working fine.
#module 4 : 6-port 1000BaseX Ethernet
set udld enable 4/2,4/5
set trunk 4/1 on dot1q 1-1005
set trunk 4/2 on dot1q 1-1005
I can’t seem to get
interface GigabitEthernet1/0/2
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1-4,1005-4094
switchport mode trunk
again on the WS-C3750-48TS-S to connect to the 4506 (Version 12.2(31)SGA8). Right now it is connected to 5-2 on the 4506 and this module is again a WS-X4306-GB. 5-2 is configured
interface GigabitEthernet5/2 – No link
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1-4,1005-4094
switchport mode trunk
and I’ve tried
interface GigabitEthernet5/2 – No link
switchport trunk encapsulation dot1q
switchport mode trunk
I'm a little over my head here... I've tried different gbic, fiber patch cables... etc... Right now I'm really thinking it is a configuration issue. Any tips?
THANK YOU
03-31-2010 10:57 AM
Hi
If your interface isn't up, it's likely a fibre/sfp issue.
Have you tried reversing the fibre pair?
Aaron
03-31-2010 11:06 AM
I have tried different g-bics on the core side but not a differnet sfp...
I'll try that now. I did try switching the fiber pair.
aaronharrison
notreply@cisco.co To
m> PAUL DICKINSON
03/31/2010 01:57 cc
PM
Subject
Please respond to message: "WS-C3750-48TS-S
"cisco-support@sg connection to 2 core switches...."
ftware.com"
aur.hosted.jiveso
ftware.com>
paul.dickinson@fandpmfg.com,
A new message was posted in the Discussion thread "WS-C3750-48TS-S
connection to 2 core switches....":
https://supportforums.cisco.com/message/3045808#3045808
Author : aaronharrison
Profile : https://supportforums.cisco.com/people/aaronharrison
Message:
03-31-2010 11:39 AM
Different sfp still doesn't link up....
aaronharrison
notreply@cisco.co To
m> PAUL DICKINSON
03/31/2010 01:57 cc
PM
Subject
Please respond to message: "WS-C3750-48TS-S
"cisco-support@sg connection to 2 core switches...."
ftware.com"
aur.hosted.jiveso
ftware.com>
paul.dickinson@fandpmfg.com,
A new message was posted in the Discussion thread "WS-C3750-48TS-S
connection to 2 core switches....":
https://supportforums.cisco.com/message/3045808#3045808
Author : aaronharrison
Profile : https://supportforums.cisco.com/people/aaronharrison
Message:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide