cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
606
Views
0
Helpful
4
Replies

Cisco Trap formats

srego4
Level 2
Level 2

I have downloaded some traps from Cisco for

6500's ios.  However I am unable to load the traps into my net mgmt software (Both CA Unicenter and

Network Node Manager).  I get the error that it is finding a fault on line 0 or 1 etc.

I have attached the traps as I got them from Cisco. WOuld anyone know what the correct syntax should be to enter in these traps.

Thanks,

4 Replies 4

yjdabear
VIP Alumni
VIP Alumni

Huh? Am I missing something? Did you try to load the actual MIBs, instead of these generic lists of trap names?

I think i did just that.  I got the link from this site

ftp://ftp-sj.cisco.com/pub/mibs/traps  

but as you mentioned, I have been trying to load them.

What's the exact error message (text or screenshot) from HPOV NNM?

I am going to load the actual mibs for these now.

The error I got when I tried to load (what I thought were the trap mibs, but were infact the 'listing' of the traps) was 'error parsing at line 0'.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco