Cisco Trap formats

srego4 · ‎03-31-2010

I have downloaded some traps from Cisco for

6500's ios. However I am unable to load the traps into my net mgmt software (Both CA Unicenter and

Network Node Manager). I get the error that it is finding a fault on line 0 or 1 etc.

I have attached the traps as I got them from Cisco. WOuld anyone know what the correct syntax should be to enter in these traps.

Thanks,

yjdabear · ‎03-31-2010

Huh? Am I missing something? Did you try to load the actual MIBs, instead of these generic lists of trap names?

srego4 · ‎03-31-2010

I think i did just that. I got the link from this site

but as you mentioned, I have been trying to load them.

yjdabear · ‎03-31-2010

What's the exact error message (text or screenshot) from HPOV NNM?

srego4 · ‎03-31-2010

I am going to load the actual mibs for these now.

The error I got when I tried to load (what I thought were the trap mibs, but were infact the 'listing' of the traps) was 'error parsing at line 0'.