OSM-2OC12-POS-SI(+) card not working

Unanswered Question
Apr 1st, 2010
User Badges:

I have a 6506 with an OSM-2OC12-POS-SI(+) card I'm attempting to move an OC12, POS circuit to.


While I'm told the OSM-2OC12-POS-SI(+) is a POS card; however when I do a show interface they are listed as ATM interfaces.  That doesn't bother me, but I can't get the POS circuits to come up.  I've tried three different cards and ensured I have the correct revision of IOS to support the card.



Is there perhaps something I'm missing in the configuration?  I've just been trying to configure them the same as any POS interface (which is nothing more than turning up the interface after adding the IP).


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Fri, 04/02/2010 - 05:38
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Gregory,


>> While I'm told the OSM-2OC12-POS-SI(+) is a POS card; however when I do a  show interface they are listed as ATM interfaces.  That doesn't bother  me,


It should ATM and POS are different matter


the configuration guide does not talk of dual mode ATM/POS modules so you cannot revert them to POS


see

http://www.cisco.com/en/US/docs/routers/7600/install_config/12.2SX_OSM_config/pos.html#wp1024676


there are OC-12 POS and OC-12 ATM


ATM uses underlying POS but you cannot expect an ATM interface to work connected to a POS port


be also aware that these linecards are in end of life


http://www.cisco.com/en/US/prod/collateral/routers/ps368/prod_end-of-life_notice0900aecd803f00c3.html


if you see two OC-12 ATM ports you have

OSM-2OC12-ATM-MM+, SI+


http://www.cisco.com/en/US/docs/routers/7600/install_config/12.2SX_OSM_config/overview.html


Hope to help

Giuseppe

Actions

This Discussion