04-01-2010 11:48 PM - edited 03-03-2019 05:54 AM
Hello,
I've just purchased an 1841 router but I can't make SDM work properly. It loads fine, but not all 'config' buttons work. On the 'Intrusion Prevention' button it sais to increase java heap size to 256MB and I did, but no change. The thing is that I have also installed ASDM for an ASA and that runs just perfect. Can anyone help me??
Thanks.
04-02-2010 04:31 AM
SDM is very buggy and does not allow professional results.
Do not use it.
04-03-2010 05:10 AM
thanks, but this isn't the answer i was looking for .
I really want to make it work.
should I install it in flash?
04-03-2010 10:55 AM
What I'm trying to tell you is that basically, does not work.
So just use CLI like everybody else.
04-26-2010 05:00 PM
Download CCP http://www.cisco.com/go/ccp and use the JRE java 6 update 17 for use with it. If you have a higher version of JRE, it will not work. CCP is the replacement for SDM since the product is end of life .
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: