Ganesh Hariharan Sun, 04/04/2010 - 22:20
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

Using network assistant was is the way to aggregate let's say the first 4 ports on the switch that go to my server that has 4 nics bridged together.



Hi Gary,

You can achieve the same by using some commands in cli mode also for creating etherchannel in cisco 3560 switches and check out the user guide for network assistant for more information. -- CLI mode for configuring etherchannel -- User guide for Network Assistant

Hope to Help !!


Cisco are currently donating money to the Haiti earthquake appeal for every rating so please consider rating all helpful posts.

william.hostetler Mon, 04/05/2010 - 16:56
User Badges:

I was looking for a more succint answer. Too many variables there on the CLI and the other one on Network Assistant was only a general one on setting up using NA.




This Discussion