04-05-2010 01:17 AM - edited 03-21-2019 09:25 AM
Why are there no wall mounting slots on the bottom of the SPA3102?
04-07-2010 04:57 PM
My 3102 has two punch outs (look like a T), see if yours has that and you can punch those out so that you can put two small screws in a wall and hang the unit via the punch outs.
07-21-2013 09:25 AM
I've tried punching them out.. just distorted the back.. then I tried carefully drilling through the back (thereby destroying one unit)..
Why didn't CISCO punch them out (while putting some barrier between the intended screws and the PCB)? I need to hang these! The only way I see now is removing the rubber (sticking) covers to the screws holding the unit together.. removing the entire back.. the trying to drill holes - this is not a typical solution - is there some point on these punchouts that will yield?
07-27-2010 11:04 AM
it should have this. in order to distribute heat.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: