Busy-Out PRI's on MGCP Gateway

Answered Question
Apr 5th, 2010
User Badges:
  • Bronze, 100 points or more

Hi,


One of our customers needs us to busy out there PRI's while they install voice firewalls.  There running CUCM 4.1 and the gateways are all MGCP.  I found the document below and I have a couple questions about the gateway reboot in step 6.  Can I do this reboot ahead of time to get ready and is it safe to leave the settings after they do there install or should I change it back?


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a008076f8d2.shtml



I hope you guys have done or seen this before.


Thanks, Mike

Correct Answer by William Bell about 6 years 11 months ago

I don't think you need to reboot the physical gateway. You simply need to enable status polling on the MGCP endpoint (in CUCM configuration mode) and do a reset on the gateway from CUCM. No reboot should be necessary.



HTH.


Regards,

Bill

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
William Bell Mon, 04/05/2010 - 13:26
User Badges:
  • Purple, 4500 points or more

I don't think you need to reboot the physical gateway. You simply need to enable status polling on the MGCP endpoint (in CUCM configuration mode) and do a reset on the gateway from CUCM. No reboot should be necessary.



HTH.


Regards,

Bill

Actions

This Discussion