cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2635
Views
0
Helpful
1
Replies

NP 1 Failed : NP Control Store Parity Error

mj11
Level 3
Level 3

Hi

I have an ACE module that has last boot reason: NP 1 Failed : NP Control Store Parity Error.

Does any one know if this is a software issue and I may need to upgarde this software I am running A2(1.5).

Regards MJ

1 Reply 1

Gilles Dufour
Cisco Employee
Cisco Employee

This is neither software or Hardware.

Our SRAM memory is quite sensitive to a lot of things and it may detect parity error once in a while.

If the frequency of the parity errors increases to something unacceptable, it is time to replace the hardware.

If you only had one occurence of this error, this is unfortunate but there is nothing to do.

Gilles.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: