Manual Allocation of dsp in router

Unanswered Question
Apr 5th, 2010
User Badges:

Hi


Can I do a manual allocation of the dsp resources in router?


1. If I have 3 PVDM, can I assign one PVDM solely for conference, one PVDM solely for transcoding?

2. Can I sub-divide a PVDM to split across differently functionalities, eg. conferencing use 1dsp, transcoding use another 1dsp out of the same PVDM?


My understanding is dsp is "automatically" assigned across the functionalities, like E1, conferencing, transcoding.


Please correct me if I am wrong.


Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Tue, 04/06/2010 - 00:15
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

Hi


Can I do a manual allocation of the dsp resources in router?


1. If I have 3 PVDM, can I assign one PVDM solely for conference, one PVDM solely for transcoding?

2. Can I sub-divide a PVDM to split across differently functionalities, eg. conferencing use 1dsp, transcoding use another 1dsp out of the same PVDM?


My understanding is dsp is "automatically" assigned across the functionalities, like E1, conferencing, transcoding.


Please correct me if I am wrong.


Thanks


Hi,


Check out the below link hope that helps


http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1003287


Ganesh.H


Remeber to rate the helpful post

Actions

This Discussion