cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
906
Views
0
Helpful
3
Replies

ACS5.0 UserChangePassword ?

coastail
Level 1
Level 1

I've a CACS-1120-K9 with base license , configured dot1x authentication for end-users, but i can't find out how to enable the UCP(UserChangePassword) function as ACS 4.x.

I know ACS5.1 could do this with "acs user-change-password" cmd

BUT , is there other way with ACS5.0 ?

REGARDS

Coast

3 Replies 3

jrabinow
Level 7
Level 7

User Change Password is not supported in 5.0

You should follow the document . If you have a single ACS server, you should first back up your 5.0 system and then perform steps as described in:

http://www.cisco.com/en/US/partner/docs/net_mgmt/cisco_secure_access_control_system/5.1/installation/guide/csacs_upg.html#wp1167547

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: