Hello's,
I have a couple Cisco AP's I'd like to get going with Power over Ethernet. Is there any way to tell from "show version" if my switch supports this? If so, what do I need to do to go about enabling?
Cisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(35)SE5, RELEA
SE SOFTWARE (fc1)
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Thu 19-Jul-07 20:06 by nachen
Image text-base: 0x00003000, data-base: 0x00D40000
ROM: Bootstrap program is C2960 boot loader
BOOTLDR: C2960 Boot Loader (C2960-HBOOT-M) Version 12.2(25r)SEE1, RELEASE SOFTWA
RE (fc1)
2960G uptime is 26 weeks, 1 day, 12 hours, 38 minutes
System returned to ROM by power-on
System image file is "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.
SE5.bin"
cisco WS-C2960G-24TC-L (PowerPC405) processor (revision E0) with 61440K/4088K by
tes of memory.
Processor board ID FOC1221X0GJ
Last reset from power-on
2 Virtual Ethernet interfaces
24 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
64K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:21:D7:99:E7:80
Motherboard assembly number : 73-10015-06
Power supply part number : 341-0098-02
Motherboard serial number : FOC12210CEA
Power supply serial number : DCA1217915B
Model revision number : E0
Motherboard revision number : A0
Model number : WS-C2960G-24TC-L
System serial number : FOC1221X0GJ
Top Assembly Part Number : 800-26673-03
Top Assembly Revision Number : B0
Version ID : V03
CLEI Code Number : COM3G00BRB
Hardware Board Revision Number : 0x01
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 24 WS-C2960G-24TC-L 12.2(35)SE5 C2960-LANBASE-M
Configuration register is 0xF
2960G#
Thanks for any help.