Hello's,

I have a couple Cisco AP's I'd like to get going with Power over Ethernet.  Is there any way to tell from "show version" if my switch supports this?  If so, what do I need to do to go about enabling?

Cisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(35)SE5, RELEA

SE SOFTWARE (fc1)

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Thu 19-Jul-07 20:06 by nachen

Image text-base: 0x00003000, data-base: 0x00D40000

ROM: Bootstrap program is C2960 boot loader

BOOTLDR: C2960 Boot Loader (C2960-HBOOT-M) Version 12.2(25r)SEE1, RELEASE SOFTWA

RE (fc1)

2960G uptime is 26 weeks, 1 day, 12 hours, 38 minutes

System returned to ROM by power-on

System image file is "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.

SE5.bin"

cisco WS-C2960G-24TC-L (PowerPC405) processor (revision E0) with 61440K/4088K by

tes of memory.

Processor board ID FOC1221X0GJ

Last reset from power-on

2 Virtual Ethernet interfaces

24 Gigabit Ethernet interfaces

The password-recovery mechanism is enabled.

64K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address       : 00:21:D7:99:E7:80

Motherboard assembly number     : 73-10015-06

Power supply part number        : 341-0098-02

Motherboard serial number       : FOC12210CEA

Power supply serial number      : DCA1217915B

Model revision number           : E0

Motherboard revision number     : A0

Model number                    : WS-C2960G-24TC-L

System serial number            : FOC1221X0GJ

Top Assembly Part Number        : 800-26673-03

Top Assembly Revision Number    : B0

Version ID                      : V03

CLEI Code Number                : COM3G00BRB

Hardware Board Revision Number  : 0x01

Switch   Ports  Model              SW Version              SW Image

------   -----  -----              ----------              ----------

*    1   24     WS-C2960G-24TC-L   12.2(35)SE5             C2960-LANBASE-M

Configuration register is 0xF

2960G#

Thanks for any help.