04-06-2010 08:59 PM - edited 07-03-2021 06:41 PM
Hi All,
Configuring a standalone 1250, and need to configure the management IP. The management for the switch/access point are not the native VLan. On a switch I'd just go "int vlan x -> ip address x.x.x.x" But on an AP there is no such option, just the BVI.
How/where do I configure the IP, if it is to be on say vlan 100? (the AP will of course be connected to the switch by .1q trunk).
Thanks.
04-06-2010 09:33 PM
Management IP address for APs is on the BVI1 (Bridged Virtual Interface).
04-06-2010 10:10 PM
Hi, thanks for the reply.
If the IP address is just applied to the BVI, how would the AP know which vlan to tag management traffic on when its sent over the .1q trunk to the neighbouring switchport? For example, the native vlan will be 1, while the management subnet (for both switch and APs) will be 100.
04-06-2010 10:16 PM
You said it yourself. The link between the Ap and the switch is dot1q trunking. From the Fast/GigEthernet you set the different VLANs for trunking.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide