04-07-2010 01:58 PM - edited 03-06-2019 10:30 AM
Hi,
I need to know if the new catalyst 2960-S support on the same model both uplink type for 1gig & 10gig?
how can we migrate from 1gig to 10gig with this same switch?
regards.
Adil
Solved! Go to Solution.
04-07-2010 02:20 PM
If you want to use 10GB, then you must use the SFP+ and for 1GB you can use SFP. The switch will support either one. Does that answer your question?
04-07-2010 02:05 PM
Adil-
The answer is in the datasheets for the 2960-S.
Hope it helps.
04-07-2010 02:10 PM
Hi collin
thk you for your response, i have previously seen this datasheet but it's not clear about support of both type of tranceiver for 10gig & 1gig.
for ht same model like Cisco Catalyst 2960S-48FPD-L. can we use both type of tranceivers?
regards
04-07-2010 02:20 PM
If you want to use 10GB, then you must use the SFP+ and for 1GB you can use SFP. The switch will support either one. Does that answer your question?
04-07-2010 02:23 PM
Maybe this link will help too-
04-07-2010 02:24 PM
is the SFP+ support both speed 1gig & 10gig or we must change the transceiver to SFP if we need just 1gig?
04-07-2010 02:25 PM
I believe the 10GB SFP+ is 10GB only. I'll see if I can find a supporting document.
04-07-2010 04:22 PM
Collin is right. The SFP+ will only support 10Gb and does not auto-negotiate to any other speed.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide