Cisco RME Netconfig

Unanswered Question
Apr 8th, 2010

Hi all,


I am using CiscoWorks RME 4.0 Netconfig to push some config.  I am creating a new Netconfig job.  After selecting a device (2621XM), I selected my user-defined SSH task.  It didn't show up on the next screen under "Applicable Tasks".  However, if I chose the system defined SSH task for the same device, the system defined SSH task showed up.


Why is my user defined task not showing up?


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
kevin.hu Thu, 04/08/2010 - 15:09

Never mind, I found out where the problem is.  Under user defined task, you can choose device type to apply the task to.

Actions

This Discussion