Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
457
Views
0
Helpful
1
Replies

Cisco RME Netconfig

kevin.hu
Level 3
Level 3

‎04-08-2010 02:44 PM

Hi all,

I am using CiscoWorks RME 4.0 Netconfig to push some config.  I am creating a new Netconfig job.  After selecting a device (2621XM), I selected my user-defined SSH task.  It didn't show up on the next screen under "Applicable Tasks".  However, if I chose the system defined SSH task for the same device, the system defined SSH task showed up.

Why is my user defined task not showing up?

Thanks!

Labels:
0 Helpful
1 Reply 1

kevin.hu
Level 3
Level 3

‎04-08-2010 03:09 PM

Never mind, I found out where the problem is.  Under user defined task, you can choose device type to apply the task to.

0 Helpful
Customers Also Viewed These Support Documents