cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
492
Views
0
Helpful
3
Replies

Can't access Management or AP Interface

neilmac
Level 1
Level 1

I am not able to ping the management or AP interface on the controller - it's a 4402 with 10 Gig spf .

Does anyone know of any issues like this ? I have set up another controller that works fine. Of course, IP and so on is all correct, I suspect a fault in the controller.

Thanks for any advise.

NSM

3 Replies 3

chad_teal
Level 1
Level 1

Were you able to get this issue resolved?

Leo Laohoo
Hall of Fame
Hall of Fame

I am not able to ping the management or AP interface on the controller - it's a 4402 with 10 Gig SFP .

WLC do NOT support 10Gb SFP.

Yes, your right, my typo, it's Gigabit, not 10 Gigabit.

The controller was faulty, it has been returned to Cisco.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: