Allocate Same Bandwidth to Multiple Cisco Router sub-interfaces

Unanswered Question
Apr 9th, 2010

Hi all,

Apologies if this has already been covered elsewhere.

I have a setup where clients connect to network resources through different

router subinterfaces each on a different network.

I would want to create a bandwith pool where two or four subinterfaces can share

the same assigned capacity either:

i,Equally

ii,or giving one subinterface priority on bandwidth

iii,or giving priority to the subinterface not using much and vice versa

Sample layout:

                        <-------- Gi0/2.4

   Pool              <-------- Gi0/2.5

(5120kbps)        <-------- Gi0/2.6

How best can I implement this?

Thanks in advance,

Chris

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ganeshh.iyer Mon, 04/12/2010 - 05:15

Hi all,

Apologies if this has already been covered elsewhere.

I have a setup where clients connect to network resources through different

router subinterfaces each on a different network.

I would want to create a bandwith pool where two or four subinterfaces can share

the same assigned capacity either:

i,Equally

ii,or giving one subinterface priority on bandwidth

iii,or giving priority to the subinterface not using much and vice versa

Sample layout:

                        <-------- Gi0/2.4

   Pool              <-------- Gi0/2.5

(5120kbps)        <-------- Gi0/2.6

How best can I implement this?

Thanks in advance,

Chris

Hi Chris,

Check out the below link for limiting the bandwidth in interfaces

http://blogs.techrepublic.com.com/networking/?p=404

http://www.ciscosystems.com/en/US/tech/tk543/tk545/technologies_tech_note09186a0080114326.shtml

Hope to Help !!

Ganesh.H

If helpful do rate the post

Actions

This Discussion