How to debug B-ACD issues?

Unanswered Question
Apr 9th, 2010


I have a UC520 with a B-ACD group configured with CCA 2.2.1.  When you call the pilot, you receive dead air then a busy signal after a bit.  I've done some debugging, and the correct dial-peer is being reached.  What debug commands can I use to get more information?  I have deleted the entire B-ACD config from CCA and removed the scripts in flash.  I also cleaned up the config by hand because CCA left a couple of ephone-dns behind.  After cleaning, I rebooted, and then configured from scratch.  CCA uploaded the scripts first of couse.  Still didn't help.

Any thoughts?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Marcos Hernandez Mon, 04/12/2010 - 08:31

Hi Joe,

Could you please open a case for this issue?

Interesting debugs are:

"debug voip ccapi inout", "debug voip dialpeer".




This Discussion