Extended Wireless LAN

Unanswered Question
Apr 11th, 2010
User Badges:

Hi 2 All,


Site A, Site B, Site C are connected to each other via T1 link in a triangle.

Each Site has its own VTP Domain, connection between site is configured as L3.

Site A got Wireless LAN Controller with 5 Access Point.

Users from Site A works mostly on Wireless LAN, these users move to SiteB and SiteC


How do I add Access Points of SiteB and SiteC to WLC of SiteA hence using the same authentication and SSID.

This would enable roaming users not to change any config for Wireless LAN.


cheers

Joe

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Sun, 04/11/2010 - 14:03
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Just use same authentication and SSID.

Jon Marshall Sun, 04/11/2010 - 14:09
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

joe.marcelo9 wrote:


Hi 2 All,


Site A, Site B, Site C are connected to each other via T1 link in a triangle.

Each Site has its own VTP Domain, connection between site is configured as L3.

Site A got Wireless LAN Controller with 5 Access Point.

Users from Site A works mostly on Wireless LAN, these users move to SiteB and SiteC


How do I add Access Points of SiteB and SiteC to WLC of SiteA hence using the same authentication and SSID.

This would enable roaming users not to change any config for Wireless LAN.


cheers

Joe


Joe


Are you asking how to extend a L2 vlan across L3 routed links ?


If so you can use L2TPv3 although you need to check whether your routers support this feature -


L2TPv3 configuration guide


Jon

Leo Laohoo Sun, 04/11/2010 - 15:26
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Depending on the firmware you are using, I recommend you prime your LWAPs prior to deployment.

Actions

This Discussion