Hello,
I have been trying for several days and have downloaded different IOS but to no luck. Can't get this AtoM to work on my Cisco 7206. I am just wondering if someone can tell me which IOS should work Following is my configuration output.
The following works on Cisco 7204 VXR. But not on my Cisco 7206. I am desperate...Please assist.
R-8(config)#int fastEthernet 1/0.123
R-8(config-subif)#encapsulation dot1Q 123
R-8(config)#pseudowire-class ETH
R-8(config-pw-class)#encapsulation ?
l2tpv3 Use L2TPv3 encapsulation
mpls Use MPLS encapsulation
R-8(config-pw-class)#encapsulation mpls
R-8(config-pw-class)#interworking ip
=========================
R-8(config)#int fastEthernet 1/0.123
R-8(config-subif)#xconnect 6.6.0.8 150 ?
encapsulation Data encapsulation method
pw-class Pseudowire-class to use for encapsulation and protocol
configuration
R-8(config-subif)#xconnect 6.6.0.8 150 pw
R-8(config-subif)#xconnect 6.6.0.8 150 pw-class ETH <--- It doesn't take this command and gives me following error.
MPLS encap is not supported on this circuit <-- This is the Error I get.
===================================================
R-8#SH VER
Cisco IOS Software, 7200 Software (C7200-P-M), Version 12.2(25)S15, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Fri 07-Dec-07 18:26 by tinhuang
ROM: System Bootstrap, Version 11.1(13)CA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(19)S, EARLY DEPLOYMENT RELEASE SOFTWARE (fc2)
R-8 uptime is 6 minutes
System returned to ROM by power-on
System image file is "disk0:c7200-p-mz.122-25.S15.bin"
Cisco 7206 (NPE200) processor (revision B) with 114688K/16384K bytes of memory.
Processor board ID 13253628
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache
6 slot midplane, Version 1.3
Last reset from power-on
Number of Fast PAs = 3
Number of Fast+Medium PAs = 4
Total number of PA bandwidth points consumed = 630
Please refer to the following document "Cisco 7200 Series Port
Adaptor Hardware Configuration Guidelines" on CCO <www.cisco.com>,
for c7200 bandwidth points oversubscription/usage guidelines.
4 Ethernet interfaces
1 FastEthernet interface
4 Serial interfaces
1 ATM interface
8 Channelized T1/PRI ports
1 Packet over SONET interface
125K bytes of NVRAM.
4096K bytes of
00:06:47: %SYS-5-CONFIG_I: Configured from console by console packet SRAM memory.
62720K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102
R-8#
