cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
623
Views
0
Helpful
4
Replies

frequent LWAP Dis association from the controller in Loc A and Loc B and associates on its own

virgoboy009
Level 1
Level 1

Hello Experts,

We are observing  frequent LWAP Dis association from the controller in Loc A and Loc B and associates on its own after 10-40mins.

Below is the error message we get when ever an AP dis associate from WLC .

CS 10.1.253.41 has detected one or more alarms of category AP and severity Critical for the following items:

AP 'AP001d.7097.33d0' disassociated from Controller '10.44.25.4'.

AP 'AP001d.7097.33d0', interface '802.11a' is down on Controller '10.44.25.4'.

AP 'AP001d.7097.33d0', interface '802.11b/g' is down on Controller '10.44.25.4'.The Access Point has lost connection with the controller.

AP 'RH-W-D189-OAC-AP1231G' disassociated from Controller '10.5.25.5'.

AP 'RH-W-D189-OAC-AP1231G', interface '802.11b/g' is down on Controller '10.5.25.5'.The Access Point has lost connection with the controller.

AP 'RH-W-D191-OAC-AP1231G' disassociated from Controller '10.5.25.5'.

AP 'RH-W-D191-OAC-AP1231G', interface '802.11b/g' is down on Controller '10.5.25.5'.The Access Point has lost connection with the controller.

E-mail will be suppressed up to 30 minutes for these alarms.

Appreciate your help.

Regards,

KA.

4 Replies 4

virgoboy009
Level 1
Level 1

Friends,

I am facing this issue on WISM module based controller which is placed on 6500 SW and running with Software Version                 4.2.176.0

Does anybody know about any issue with this version image on WISM .

Please advise!

Regards,

KA.

I'm using 6.X and I don't see this issue at all.

Hello Leo,

Thanks for your posts.

Do you mean is there any bug involved with 4.2.176 image .

Actually i am having this issue with WISM controllers  with image on 4.2.176 and do not have issue with some other places by having

WLC 4402 -4.1.185.0 & WLC-2106 .X image .

All these WISM, WLC 4402,2106 are added for Alarm email notificaion in WCS.

Regards,

KA.

It's been awhile since I've used the 4.X firmware so I wouldn't remember what the stuffs were.  I do recall when I was using the 5.X firmware I would get regular alarms about the LWAPs radios being reset.  After upgrading to 6.X the alarms stopped.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: