E1(PSTN) <--> 2821 <--(MGCP)--> CCM 7.x <--(H323)--> VG224. Is this possible ??

Unanswered Question
Apr 14th, 2010
User Badges:

Hi all,


I am hoping to implement such installation. Since all phones are to use dialplans in CCM 7.x, can the faxes uses dialplans in VG224 in the form of dial-peers? Can this be done? If so, please advise.


Cisco2821 communicates with CCM 7.x using MGCP protocol

VG224 communicates with CCM 7.x using H323 protocol.


Best regards,

Lawrence Chew

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Aaron Harrison Wed, 04/14/2010 - 07:59
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015

Hi


Yes, it's perfectly possible. Each device only communicates with CCM for signaling, so you can run as much of a mix of H.323, SCCP, MGCP, SIP as you like.


It's more common however to run MGCP (for simplicity) or SCCP (for features) on the VG224.


Regards


Aaron


Please rate helpful posts..

wfchew2007 Wed, 04/14/2010 - 08:29
User Badges:

Hi Aaron,


Probably it is easier to configure with MGCP/SCCP. But I have known of some implemetors which prefer to do it in H323 because of easier and simplicity of troubleshooting.


Can you provide the link to setup in VG224 interoperate with CCM 7.x using H323 setup? This will be a great helps.


Best regards,

Lawrence Chew

wfchew2007 Wed, 04/14/2010 - 08:48
User Badges:

Hi Aaron,


This doc seem useful. Will read thru. Thanks.


Best regards,

Lawrence Chew

Actions

This Discussion