04-14-2010 07:46 AM - edited 03-19-2019 12:46 AM
Hi all,
I am hoping to implement such installation. Since all phones are to use dialplans in CCM 7.x, can the faxes uses dialplans in VG224 in the form of dial-peers? Can this be done? If so, please advise.
Cisco2821 communicates with CCM 7.x using MGCP protocol
VG224 communicates with CCM 7.x using H323 protocol.
Best regards,
Lawrence Chew
04-14-2010 07:59 AM
Hi
Yes, it's perfectly possible. Each device only communicates with CCM for signaling, so you can run as much of a mix of H.323, SCCP, MGCP, SIP as you like.
It's more common however to run MGCP (for simplicity) or SCCP (for features) on the VG224.
Regards
Aaron
Please rate helpful posts..
04-14-2010 08:29 AM
Hi Aaron,
Probably it is easier to configure with MGCP/SCCP. But I have known of some implemetors which prefer to do it in H323 because of easier and simplicity of troubleshooting.
Can you provide the link to setup in VG224 interoperate with CCM 7.x using H323 setup? This will be a great helps.
Best regards,
Lawrence Chew
04-14-2010 08:32 AM
Hi
It's an IOS gateway; so anyone who has configured H.323 on a Cisco device for CallManager before should be right at home.
There's a basic example in the config guide : http://www.cisco.com/en/US/docs/routers/access/vg224/software/configuration/guide/scgappa.html
Regards
Aaron
04-14-2010 08:48 AM
Hi Aaron,
This doc seem useful. Will read thru. Thanks.
Best regards,
Lawrence Chew
04-14-2010 08:55 AM
No problem
Please rate helpful posts and mark answered questions that you've got a satisfactory response from..
https://supportforums.cisco.com/docs/DOC-6212
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide