Cisco Aironet LR2 power injector - can't console into it?

Unanswered Question
Apr 14th, 2010


We have 2 Cisco Aironet Power Injector LR2's (AIR-PWRINJ-BLR2=) and I can't console to either using Cisco sky blue consoel cable.

I am using putty and my setting are:

Speed = 9600

Data Bits = 8

Stop Bits = 1

parity = none

Flow control = none

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Wed, 04/14/2010 - 15:37

I don't believe you can console into a power injector.  Why, if I should ask, are you doing this?

Andy White Wed, 04/14/2010 - 23:04

I was curious that's all. I have a 1301G to connect to it, is it used to configure that?


Andy White Thu, 04/15/2010 - 22:43

How do I configure the 1301 that connects to it via coaxial and why does the LR2 have a console port in the first place?

haroldlda Sat, 12/17/2011 - 22:39

I spend the same, the AP 1310 is OK, but the power led led off injector LR2. Consoledoes not work

haroldlda Sun, 12/18/2011 - 09:15

Console Cable is ok, but led off power injector. AP LED is ok

Leo Laohoo Sun, 12/18/2011 - 13:35
Console Cable is ok

I'm not talking about the console cable.  The ethernet cable from the injector to the WAP could be faulty.


This Discussion