cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
6219
Views
0
Helpful
10
Replies

Cisco Aironet LR2 power injector - can't console into it?

Andy White
Level 3
Level 3

Hello,

We have 2 Cisco Aironet Power Injector LR2's (AIR-PWRINJ-BLR2=) and I can't console to either using Cisco sky blue consoel cable.

I am using putty and my setting are:

Speed = 9600

Data Bits = 8

Stop Bits = 1

parity = none

Flow control = none

10 Replies 10

Leo Laohoo
Hall of Fame
Hall of Fame

I don't believe you can console into a power injector.  Why, if I should ask, are you doing this?

I was curious that's all. I have a 1301G to connect to it, is it used to configure that?

Thanks

Oh no. 

The power injector has only two options:  On or Off.

How do I configure the 1301 that connects to it via coaxial and why does the LR2 have a console port in the first place?

Under Network Management

The power injector does not require configuration or management.

Cisco Aironet 1300 Series Access Point/Bridge Power Injector
http://www.cisco.com/en/US/products/ps5861/products_data_sheet09186a008022551d.html

Go to the website posted below.  Choose from either Configuration Examples & TechNotes or Configuration Guides.

http://www.cisco.com/en/US/customer/products/ps5861/tsd_products_support_configure.html

Hope this helps and please don't forget to rate our posts.  Thanks.

I spend the same, the AP 1310 is OK, but the power led led off injector LR2. Consoledoes not work

but the power led led off injector LR2

Faulty cable to the WAP.

Console Cable is ok, but led off power injector. AP LED is ok

Console Cable is ok

I'm not talking about the console cable.  The ethernet cable from the injector to the WAP could be faulty.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: