Inline WAVE supporting trunking

Answered Question
Apr 15th, 2010

I have a WAVE-674 with a four-port inline module. On the remote end, they are trunking between the router and the switch, where I'll place the WAVE. If I'd like for the inline module/WAVE to detect the 802.1q trunk headers and optimize for all VLANs, is it as simple as:

interface InlineGroup 1/0
inline vlan all
exit

The CCO doc isn't too explicit and I won't have time to "play" with config options, the office has to come immediately back up after inserting into the network.

Thanks!

Correct Answer by Zach Seils about 6 years 10 months ago

By default when a WAAS device is deployed using the Inline Module, traffic on all VLANs will be intercepted and evaluated for optimization.

Regards,

Zach

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Zach Seils Wed, 04/21/2010 - 09:12

By default when a WAAS device is deployed using the Inline Module, traffic on all VLANs will be intercepted and evaluated for optimization.

Regards,

Zach

mmertens@iplogi... Wed, 04/21/2010 - 09:17

Thanks Zach, So then, WAVE can automatically detect whether there are 802.1q trunk headers or not- and to your point, will by default begin to optimize all the tagged (and untagged) traffic.

Just wanted to make sure.

Thanks Zack.

Actions

This Discussion