PXE Boot over IPSec Tunnel

don.click1 · ‎04-15-2010

Is it possible to have a PC use the PXE boot to an image server of an IPSEC site to site tunnel?

ie:

PC --> ASA5505 --> ipsec (full) tunnel --> ASA5520 --> Image Server

If this is possible, could someone point me to a cofnig document?

Thanks!

Federico Coto Fajardo · ‎04-15-2010

Hi,

I don't have a document, but if the traffic falls into the IP protocol and uses unicast as transmission, then it should pass with no problems thru the IPsec tunnel.

Plain IPsec between ASAs does not pass multicast, broadcast or any other protocol that does not run in IP.

Federico.