04-16-2010 05:31 AM
Hello I'm updating the software on about 200 3750 stacks. During the verification process I'm used to get a warning with the messages swim1132,1201 and 1106. But jobs run then successfully.
But sometimes the verification step fails with the SWIM1200 error. That is a litte strange because all the switches have the same flash size of 15998976 bytes.
The error messages are in the attachment.
I woult be very happy, if somebody can give me an advice.
Markus Schwendimann
Basel, Switzerland
04-16-2010 11:30 PM
This is CSCsu49349. The bug is fixed in RME 4.3. The workaround is to go to RME > Software Mgmt > Software Repository, then click on the name of the image. Reduce its required flash size down one setting (i.e. make the requirement 8 MB). This will allow the image to deploy properly.
--
Please support CSC Helps Haiti
https://supportforums.cisco.com/docs/DOC-8895
https://supportforums.cisco.com
04-19-2010 04:03 AM
Hi Joe
Thanks for the tip but ....
I tried to change the "minimum flash value" in der sw repository. But it doesn't work. If I change the value,click ok and then click again on the name of the image then I see still the old value. I do that with admin rights.
Markus
04-19-2010 08:25 AM
You need to click the Update button in the file attributes dialog.
04-19-2010 11:45 PM
Many thanks, it's all ok now. The obvious will always be easily overlooked.
Kind regards, Markus
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide