Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

WCS Showing one client associated to two AP´s

Unanswered Question
Apr 16th, 2010
User Badges:


I´m working on a wireless project that uses some LAP´s 1250, 3 controllers 5508 and a WCS software to manage everything. In one of the areas there are a lot of users, around 90, this area has 6 LAP´s. Some of those clients frequently migrate from one AP to the other. When this happens the WCS shows that client is associated with two AP´s. But when I check the clients list on the controllers, the client is only at one LAP. We are using WCS Version Do you have any problem link this? Is it a WCS bug?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
chad_teal Tue, 04/20/2010 - 12:28
User Badges:

I haven't run into this issue.  This is just a guess but I'm wondering if the client association information is just delayed between WCS and the WLC after a client roams.  You could check the client history and see the amount of time the client was associated to each access point and try to figure out what is going on.

sschmidt Tue, 04/27/2010 - 09:47
User Badges:
  • Cisco Employee,

Does the client eventually show up on only one AP?  What is the timeframe?


This Discussion

Related Content



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode