UCM6.1 Route Groups and SIP Trunks

Unanswered Question
Apr 19th, 2010

I have the following case:

I need to configure a route group that contain 3 SIP Trunks, however in the Rout Group configuration page the SIP Trunks are not listed under the availabe devices. I'm using UCM

However, in UCM 7.1 I do have the SIP trunks listed under the available devices for the Rout Group configuration page!

Dose any one have this limitations also?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Aaron Harrison Mon, 04/19/2010 - 00:23


If you have a Route Pattern pointed directly at the Route Group, it will be hidden - remove the RP, and you'll be able to add it to a route group.



Please rate helpful posts...


This Discussion