Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
387
Views
0
Helpful
1
Replies

UCM6.1 Route Groups and SIP Trunks

Zaid Ahmaad Ibrahim Al-Taiar
Level 5
Level 5

‎04-19-2010 12:14 AM - edited ‎03-15-2019 10:19 PM

I have the following case:

I need to configure a route group that contain 3 SIP Trunks, however in the Rout Group configuration page the SIP Trunks are not listed under the availabe devices. I'm using UCM 6.1.5.10000-10

However, in UCM 7.1 I do have the SIP trunks listed under the available devices for the Rout Group configuration page!

Dose any one have this limitations also?

Regards,

Labels:
0 Helpful
1 Reply 1

Aaron Harrison
VIP Alumni
VIP Alumni

‎04-19-2010 12:23 AM

Hi

If you have a Route Pattern pointed directly at the Route Group, it will be hidden - remove the RP, and you'll be able to add it to a route group.

Regards

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents