Procurve 5304xl and Cisco 3560

Unanswered Question
Apr 21st, 2010
User Badges:

I am trying to make operational inter-vlan routing between Procurve 5304xl as core switch and Catalyst 3560 as access switch, I have tried multiple time to make operation inter-vlan routing but no home. Actully I have 3560 PoE switch and I need to start IP telephony.


Any help for solution ? thank you in advance for solution.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Wed, 04/21/2010 - 01:03
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

zeeshan-aziz wrote:


I am trying to make operational inter-vlan routing between Procurve 5304xl as core switch and Catalyst 3560 as access switch, I have tried multiple time to make operation inter-vlan routing but no home. Actully I have 3560 PoE switch and I need to start IP telephony.


Any help for solution ? thank you in advance for solution.


Zeeshan


Have you tried looking on the HP site for their config docs ?


What exactly is the problem ? If the procurve is actually doing the inter-vlan routing then on the 3560 switch all you need is the vlans created at L2 and a trunk link back to the procurve switch.


Jon

Zeeshan Aziz Wed, 04/21/2010 - 02:27
User Badges:

Hi John

I had go through at HP site but I just found number of same queries and no one able to solve the mystry to get solution. In fact what you asked I had tried the same by making 3560 as L2 but didn't work. I was able to manage and start communication between HP and 3560 switch, but when I tried to configure two access vlan ports on each, as I had PoE 3560 to start IP telephony, but communication did not work with two vlan (one for voice and one for data) on each port of Catalyst 3560.

Actions

This Discussion