04-21-2010 06:19 AM - edited 07-03-2021 06:44 PM
We have 3 1130's installed and 2 vlans, one public and one private. I need to broadcast my private SSID but cannot find the setting to allow this. Can someone advise me on the location of the setting?
chaz
04-21-2010 06:43 AM
Charles,
I assume you are using IOS (Autonomous) Access points.. if so you need to enable guest-mode on the Dot11 SSID
so it would look something like this
dot11 ssid private
vlan x
guest-mode
Hope this helps.. Please feel free to rate it.
04-21-2010 07:28 AM
Forgive my response/confusion but in using the web interface, where is this setting held?
04-21-2010 06:53 PM
It should be under Security -> SSID towards the bottom of the page you will need to scroll the select Guest ID and the SSID you want broadcast.
Bill
04-21-2010 06:55 PM
Dumb follow up, but the device cant broadcast both SSID's?
04-21-2010 07:30 PM
Yes, you can broadcast up to 16 SSID.
04-21-2010 07:34 PM
I can get one or the other to broadcast but not both. What am I doing incorrect?
04-21-2010 07:37 PM
Go to Security > SSID Manager. Highlight the SSID you want and go down and tick "Set SSID as Guest Mode".
04-21-2010 08:36 PM
Don't forget to rate our posts. Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: